With a bridge at home you reach your printers from anywhere and from the browser – status, camera, printing, time-lapse. The bridge only connects outwards: nothing to open in your router, your printers stay off the internet.
| Part | What to look for | approx. |
|---|---|---|
| Raspberry Pi 3 Model B (or 3B+, 4, 5) | A Pi 3 is plenty. It has an Ethernet socket – that matters. | €38 |
| Power supply | For the Pi 3: micro-USB, 5 V, 2.5 A (ideally the official one). Pi 4/5: USB-C (3 A / 5 A). | €10 |
| microSD card | 16 or 32 GB, a brand card (e.g. SanDisk, Samsung). | €8 |
| Case | Matching the model, so nothing shorts. | €6 |
| Network cable | From the Pi to your router (or a network switch). There's often one lying around. | €3 |
Available from electronics shops such as The Pi Hut, Pimoroni, Berrybase or Reichelt. Once: a computer with a card reader (or a USB card reader for a few euros).
We provide a ready-made card image: Raspberry Pi OS with the bridge already on it.
Download the PocketPrint3D image (about 750 MB, for the Raspberry Pi 3, 4 and 5). No need to unpack it.
Install Raspberry Pi Imager on your computer (Windows, Mac or Linux) and put the microSD card in. In the Imager: Device: your Raspberry Pi → Operating system: Use custom → the downloaded file → Storage: your SD card → Next. If it asks about customising settings: No. Then Write – takes a few minutes.
Card into the Pi, network cable to the router, the power supply last. The first start takes about 3 minutes.
With your phone on your home Wi-Fi, open the PocketPrint3D app: Settings → Advanced → Print from anywhere. The bridge appears under Found on your Wi-Fi – tap it. Then Add a printer through the bridge – the bridge finds your printers itself. Done!
On a computer on the same network, open http://pocketprint3d.local. The page shows a
pairing code (e.g. K7Q4-M2ZX): at app.pocketprint3d.com go to
Settings → Advanced → Print from anywhere, enter the code → Connect.
http://192.168.1.42.Safe by design: the image has no default password and no remote login (SSH) – nobody can log in to the Pi. The pairing code is only shown on your home network. The image is built openly on GitHub from pi-image/.
Connect a Raspberry Pi camera (e.g. Camera Module v2) to the Pi and it is available right away at
rtsp://Pi-address:8554/cam – enter it as your printer's Own camera in the app. Picture
upside down? Add #rotate=180.
For a Raspberry Pi Zero 2 W (Wi-Fi only), a Pi you already use, or any Debian/Ubuntu computer: install
Raspberry Pi OS Lite (64-bit) with the Imager as usual (with Wi-Fi and SSH in its settings), log in with
ssh and run one command:
curl -fsSL https://pocketprint3d.com/install-bridge.sh | sh
It installs Docker and the bridge into /opt/pocketprint3d-bridge and shows the pairing code at the end (again
with pocketprint3d-code). Read it first: install-bridge.sh.
Questions or problems: GitHub.